Configuration Of Unencoded Components - Leica SmartTouch Manual

Configuration of Unencoded Components

Unencoded components (such as an
objective) are not detected automati-
cally by the Leica SmartTouch™. To ensure that
these components are included in the various
calculations (depth of field, zoom factor, etc.)
correctly, they must be configured in the Leica
SmartTouch™.
These configurations must be carried out
on the following occasions:
Initial commissioning of the microscope.
Ϙ
After an unencoded component has been
Ϙ
replaced by a component with different
properties.
After the Leica SmartTouch™ has been reset
Ϙ
to the factory defaults.
Leica SmartTouch™
Registering components
1. Touch the "Config." tab.
2. In the left area, touch the symbol for the
microscope accessories.
3. Touch the symbol of the instrument compo-
nent that you would like to detect.
Manual
4. In the list with the available components,
touch the components you are using.
5. Repeat steps 3 and 4 for all components
that you would like to use.
Each change is stored immediately.
Restarting the instrument is not required.
24