Table of Contents
Advertisement
LP CYLINDER TRANSPORTATION & STORAGE
• The LP cylinder must include a collar to protect the gas supply valve.
• Do not store a spare LP cylinder under or near the Hot Food Table.
• Never fill the LP cylinder beyond 80% capacity.
• If the warnings 2 and 3 above are not heeded exactly, a fire causing death or serious injury may occur.
• Always transport in an upright position.
• Do not smoke when transporting your LP cylinder.
• Place a dust cap on the cylinder gas valve outlet whenever the cylinder is not in use.
• Use only the type of dust cap that is provided with the cylinder valve when purchased.
Other types of cap or plugs may result in leakage of propane.
CONNECTING REGULATOR TO LP CYLINDER
CAUTION:
Only use the gas pressure regulator provided with this outdoor cooking appliance.
This regulator is set for an outlet pressure of 11 inches water column.
WARNING:
Always keep the gas cylinder valve in the upright position at all times.
NOTE:
Your regulator is equipped with a QCC Type 1 quick connect system. It does not allow gas to flow
until a positive seal has been made. It has a thermal element that will shut off the gas flow if the
temperature reaches 115 °C (240 °F).
NOTE:
It also has a flow-limiting device that restricts the flow of gas to 0.28 cubic metrics per hour
(10 cubic feet per hour).
NOTE:
Before attaching to your Hot Food Table, perform a cylinder leak test through the instructions
listed in "STEPS FOR LEAK TEST" section.
1. Make sure the LP cylinder is OFF by turning the hand wheel clockwise until it stops.
2. Place the cylinder under the gas Hot Food Table body with the valve facing outward. See Assembly
instructions to secure the cylinder into the nesting hole located in the bottom shelf of the gas Hot Food
Table body.
3. Be sure all burner controls are turned to the OFF position.
4. Remove the safety cap from the cylinder valve.
5. Center the regulator nipple into the cylinder valve.
6. Turn the coupling nut clockwise until it can no longer be tightened by hand (do not use a wrench).
LP Cylinder Information | 11
Operating Instructions |
Dust Cap
The regulator must enter the
cylinder valve in a straight line.
!
WARNING
Always keep the gas cylinder in
the upright position at all times.
03
P.
DUST CAP
QQC TYPE 1
Center the regulato
into the cylinder val
Center the regulator
nipple into the
cylinder valve.
The regulator must enter
the cylinder valve in a
straight line.
shopbackyardpro.com
Advertisement
Table of Contents
