Connect Power; Charge The Battery Pack; Charge From A Usb Port On A Host Device - Honeywell CT4 Series User Manual

Connect Power

You can charge your unit via the snap-on adapter by connecting it to a USB port on
a host device or with the optional 5VDC/2A wall charger (p/n 50130570-001).
The operating temperature is -10 °C to 50 °C (-14 °F to 122 °F).

Charge the Battery Pack

Charge from a USB port on a Host Device

Charging the battery through a USB port takes more time than direct charging
using the optional wall charger.
1. Connect the USB cable to your personal computer.
2. If your computer does not have a boot attached, insert the adapter into the
3. Insert the computer with battery installed into the holding bay until the latches
Note: Inadequate source current may lengthen the charge time or prevent the battery from
charging if the terminal is drawing more current than supplied by the USB port.
42
holding bay of the snap-on USB adapter.
click.
Mobile computer
without protective
boot
Adapter
Mobile computer
with protective
boot
CT4x Series Accessories User Guide