Install The Software - Honeywell CT4 Series User Manual

5. Select Download next to the software zip file.

Install the Software

Note: The computer must have power for the entire length of the install process or it could
become unstable. Do not attempt to remove the battery during the process.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Provisioning mode under Honeywell settings.
3. Tap the toggle button to turn Provisioning mode On.
4. Connect the computer to your workstation.
5. On the computer, swipe down from the top of the screen to see the
6. Tap USB charging this device.
7. Select Transfer files.
8. Open the browser on your workstation.
9. Save the DisplayLink Presenter file (*.apk), version 2.3.0 or higher, in one of the
10. Swipe up from the bottom of the Home screen to access all apps.
11. Tap AutoInstall Settings and verify AutoInstall is enabled.
12. Tap Packages Upgrade from the AutoInstall Settings screen. The computer will
13. Once installation is complete, turn Provisioning mode Off.
32
notifications.
following folders on the CT40 mobile computer:
• Internal shared storage\honeywell\autoinstall
Files saved to this folder for installation do not persist when a Full factory
reset or Enterprise data reset is performed.
• IPSM card\honeywell\autoinstall
Files saved to this folder for installation do not persist when a Full factory
reset is performed. However, the software does persist if an Enterprise data
reset is performed.
initiate a reboot and install the software. When the install is finished, the lock
screen appears.
CT4x Series Accessories User Guide