Adhesive Tape Mounted Scale; Cleaning Scales - Celera Motion MicroE ChipEncoder Series Installation Manual And Reference Manual

ChipEncoder Series
Installation Manual and Reference Guide

5.4.2 Adhesive Tape Mounted Scale

Linear scale is permanently attached to the mounting surface using double-sided adhesive tape on the
back of the scale.
Note: Use talc-free gloves or finger cots to handle the scales.
Refer to the following drawing for this procedure:
End Benching
Pin
Step Action
1. Make sure that the mounting surface is dry and clean.
2. Peel the cover paper off and place the scale above the final location.
3.
Align the scale by placing the edges against the benching pins.
4. Gently place the scale on the mounting surface.
5. When scale is in final position, firmly press down on the top of the scale to secure it.
6.0

Cleaning Scales

Step Action
1. General Particle Removal:
Blow off any contamination with nitrogen, clean air, or a similar gas.
2. Contamination Removal:
Use a lint-free cleanroom wipe or cotton swab dampened with isopropyl alcohol or acetone to
wipe the surface clean. Handle the scale by the edges. Do not scrub the scale.
IM-ChipEncoder-Series-Rev. 2
L
Benching Pins
Page 17
Cleaning Scales
©2022 Celera Motion