Operation - Husqvarna CT 36A/A-V Operator's Manual

4. Hold the throttle control in the idle speed position
while you put the bracket (B) on top of the throttle
cable.
5. Install the air filter assembly if it was removed.
To connect the wires from the handle to
the engine
1. Connect the wires (A) from the handle to the yellow
wires (B) from the engine.
2. Connect the green ground wire from the handle to
the green wire from the engine.
a) If the product has a green wire installed on the
engine, discard the green wire supplied with the
handle.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Do a check of the safety devices on the product.
Safety devices on the product on page 7 .
Refer to
• Do the daily maintenance. Refer to
schedule on page 16 .
1452 - 003 - 30.01.2023
A
B

Operation

Read and understand the
Maintenance
b) If the product does not have a green wire
installed on the engine, remove the nut (C),
install the ground wire and tighten the nut to 24
Nm/18 lb-ft.
To do a function check after assembly
1. Start the engine. Refer to
page 12 .
2. Do a check of the idle speed and the clutch. Refer to
Technical data on page 25 for the correct value.
a) Make sure that the blades do not rotate when the
engine is at idle speed.
b) Increase the engine speed and make sure that
the blades start to rotate.
3. Do a check of the gyroscopic safety switch. Refer
To do a check of the gyroscopic safety switch on
to
page 8 .
C
To start the product on
11