Table of Contents
Advertisement
To replace the belt
WARNING:
without the belt cover installed.
1. Stop the engine and disconnect the spark plug
cable.
2. Remove the screws and washers that hold the belt
cover. Remove the belt cover.
a) A-V models:
b) All other models:
18
Do not operate the product
3. Slowly turn the pulley while you remove the belt from
the pulley.
CAUTION:
clutch or the pulley when you replace
the belt. The clutch and the pulley are
aligned at the factory.
4. Install a new belt.
5. Install the belt cover, the washers and the screws.
Torque the screws to 5 Nm/3.7 lb-ft.
To lubricate the blade shafts
•
Push grease through the grease nipples until grease
comes out around the blade shafts. Refer to
Technical data on page 25 .
To replace the blades
WARNING:
blades, stop the product, make sure that the
engine is cool and remove the spark plug
cable.
Do not remove the
Before you replace the
1452 - 003 - 30.01.2023
Advertisement
Table of Contents
