Table of Contents
Advertisement
•
Disconnect the spark plug cap before you do the
maintenance.
•
Worn blades can have sharp edges. Use protective
gloves and be careful around the blades.
•
The exhaust fumes from the engine are hot and can
contain sparks. Do not operate the product in indoor
areas or near flammable material.
•
Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
•
Always use original accessories and approved spare
parts. Accessories and spare parts that are not
approved by the manufacturer, can cause serious
injury or death.
To assemble the handlebar
1. On CT 36-5A EU FOLD-ADJ-T: Lift the handle until it
is straight and tighten the knob (A).
2. Attach the wires to the handlebar with cable ties.
To install the handle
1. Pull the blade pitch cable (A) from the bottom end of
the handle and remove the cable nut (B).
1452 - 003 - 30.01.2023
Assembly
A
A
B
•
Replace damaged, worn or broken parts.
•
Only do the maintenance as described in this
operator's manual. Let an approved service center
do all other servicing.
•
Remove all tools from the product before you start
the engine after maintenance. Loose tools or tools
attached to rotating parts can eject and cause injury.
•
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service center.
•
Let an approved service center do servicing on the
product regularly.
2. Remove the 2 bolts (C) and the 2 nuts (D) from the
handle holder.
D
3. Lubricate the blade pitch cable. Refer to
data on page 25 .
4. Put the blade pitch cable above the pulley and out
through the slot (E).
E
C
Technical
E
9
Advertisement
Table of Contents
