Return To Neutral Assembly - Hydro-Gear ZT-2800 Service And Repair Manual

RETURN TO NEUTRAL ASSEMBLY

Refer to Figure 8
Disassembly
1. Remove all items previously discussed in
their recommended order.
2. Remove the RTN control arm kit (211) by
first removing the spring (147) and Torx
head screw (46), discard the screw. The
remaining members of the assembly can be
removed as a single item – washer (146),
unidirectional scissor arm kit (145), and the
control arm (44).
3. Remove the Allen head screw (142), washer
(45), neutral arm (141) and spacer (140).
NOTE: Only remove the seal (41) if damaged
or worn. The seal is not part of the
RTN control arm kit (211), and cannot
be serviced separately. Refer to "Seal
Kit" in the Items List on pager 46.
Inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
14
Assembly
1. Reassemble all parts in the reverse order
2. When tightening the fasteners, refer to the
3. Refer to the RTN adjustments on page
NOTE: As a general rule, use the low end of
141
140
41
Figure 8, Return to Neutral Assembly
of disassembly.
table on page 22 for the required torque
values.
13.
the torque specification on fasteners
when reassembling the unit.
211
145
44 142
45
Refer to "Return to Neutral Setting"
On Page 13.
146
147
ZT-2800 /ZT-3100 /ZT-3200
® ®
46
TM