Safety; Personal Safety; Tool Safety; Work Area Safety - Hydro-Gear ZT-2800 Service And Repair Manual

SAFETY

This symbol points out important safety
instructions which, if not followed, could en-
danger the personal safety and/or property of
yourself and others. Read and follow all instruc-
tions in this manual before attempting mainte-
nance on your transaxle. When you see this
symbol - HEED ITS WARNING.
WARNING
POTENTIAL FOR SERIOUS INJURY
Inattention to proper safety, operation, or
maintenance procedures could result in
personal injury, or damage to the equip-
ment. Before servicing or repairing the
transaxle, fully read and understand
the safety precautions described in this
section.

Personal Safety

Certain safety precautions must be observed
while servicing or repairing the transaxle. This
section addresses some of these precautions
but must not be considered an all-inclusive
source on safety information. This section is
to be used in conjunction with all other safety
material which may apply, such as:
1. Other manuals pertaining to this machine,
2. Local and shop safety rules and codes,
3. Governmental safety laws and regula-
tions.
Be sure that you know and understand the
equipment and the hazards associated with it.
Do not place speed above safety.
Notify your supervisor whenever you feel there
is any hazard involving the equipment or the
performance of your job.
Never allow untrained or unauthorized person-
nel to service or repair the equipment.
ZT-2800 ZT-2800 /ZT-3100 /ZT-3200
® ® ® TM
Wear appropriate clothing. Loose or hanging
clothing or jewelry can be hazardous. Use the
appropriate safety equipment, such as eye and
hearing protection, and safety-toe and slip-proof
shoes.
Never use compressed air to clean debris from
yourself or your clothing.

Tool Safety

Use the proper tools and equipment for the task.
Inspect each tool before use and replace any tool
that may be damaged or defective.

Work Area Safety

Keep the work area neat and orderly. Be sure
it is well lit, that extra tools are put away, trash
and refuse are in the proper containers, and dirt
or debris have been removed from the working
areas of the machine.
The floor should be clean and dry, and all ex-
tension cords or similar trip hazards should be
removed.

Servicing Safety

Certain procedures may require the vehicle to be
disabled in order to prevent possible injury to the
servicing technician and/or bystanders.
The loss of hydrostatic drive line power may result
in the loss of hydrostatic braking capability.
Some cleaning solvents are flammable. Use only
approved cleaning materials: Do not use explo-
sive or flammable liquids to clean the equipment.
To avoid possible fire, do not use cleaning sol-
vents in an area where a source of ignition may
be present.
"Discard used cleaning material in the ap-
propriate containers according to local,
state, and federal regulations."
7 7