Return To Neutral Assembly - Hydro-Gear ZT-2800 Service And Repair Manual

reTUrn TO neUTraL asseMBLY

Refer to Figure 8
disassembly
1. Remove all items previously discussed in
their recommended order.
2. Remove the RTN control arm kit (211) by
first removing the spring (147) and Torx
head screw (46). The remaining members
of the assembly can be removed as a single
item – washer (146), unidirectional scissor
arm kit (145), and the control arm (44).
3. Remove the Allen head screw (142), washer
(45), neutral arm (141) and spacer (140).
NOTE: Only remove the seal (41) if damaged
or worn. The seal is not part of the RTN
control arm kit (211), and cannot be
serviced separately. Refer to "Seal Kit"
in the Items List on pages 43 or 45.
inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
14
assembly
1. Reassemble all parts in the reverse order
2. When tightening the fasteners, refer to the
3. Refer to the RTN adjustments on page
NOTE: As a general rule, use the low end of
141
140
41
figure 8, return to neutral assembly
of disassembly.
table on page 21 for the required torque
values.
13.
the torque specification on fasteners
when reassembling the unit.
211
145
44 142
45
R "R
efeR to etuRn to
o P 13.
n age
ZT-2800
46
146
147
n S "
eutRal etting
/ZT-3100™/ZT-3400™
®