Axle Shaft - Hydro-Gear ZT-2800 Service And Repair Manual

AXLE SHAFT (ZT-2800
Refer to Figure 36
Disassembly
1. Remove all items beginning on page 14.
2. Remove the retaining ring (90).
3. Remove and discard the lip seal (96).
4. Remove the axle shaft (94) in the direction
of arrow.
5. Remove the bearing (95).
NOTE: Remove the bearing from the axle shaft
only if worn or damaged.
Inspection
1. Inspect the splines on the axle shaft for wear
or damage. Replace if necessary.
2. Inspect the bearing (95) for wear or damage.
Replace if necessary.
94
ZT-2800 /ZT-3100 /ZT-3200
® ®
/ZT-3100
®
Figure 36, Axle Assembly
TM
)
®
Assembly
1. Assemble items in reverse order of disas-
sembly.
NOTE: To protect the lip seal from possible
damage when installing into the bore
and over the axle shaft, apply a protec-
tive covering over the splines, sharp
corners and/or keyway of the axle shaft
(e.g., cellophane, tape, etc.).
95
90
96
39