Table of Contents
Advertisement
Cleaning the filter
1. Wash the filter in warm water using a mild
cleaning agent.Wash the filter in warm
water without any cleaning agents.
Detergents can damage the odour
filtration. You can use a soft sponge, a
soft cloth, or a non-abrasive cleaning
brush to remove food remains, if
necessary. You can also wash the filter in
a dishwasher at 65-70 °C (using a
program longer than 90 min), without
detergents and without dishes in the
same load.
2. Dry the filter in the oven for 20-30 min at
70 °C. Place the filter on the middle wire
shelf. Make sure to use a non-fan oven
function. Alternatively, you can leave the
filter to dry overnight at room
temperature. The filter needs to be fully
dried before reassembly.
10. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
10.1 What to do if...
Problem
You cannot activate or operate
the hob.
You can hear a constant beep
noise.
3. Reassemble the filtering unit and put it
4. If the notification
The counter restarts.
Regenerating the filter
1. Clean the filter first, as described above
2. Put the filter in the oven set to 80-110 °C
3. Reassemble the filtering unit and put it
4. Press
The counter restarts.
Possible cause
The hob is not connected to an elec‐
trical supply or it is connected incor‐
rectly.
The fuse is blown.
You did not set the heat setting for
60 seconds.
You touched 2 or more sensor fields
at the same time.
Pause operates.
There is water or fat stains on the
control panel.
The electrical connection is incor‐
rect.
back inside the hood cavity.
briefly to reset the counter.
in step 1.
for 60 min. Place the filter on the middle
wire shelf. Use a non-fan oven function.
back inside the hood cavity.
briefly to reset the counter.
Remedy
Check if the hob is correctly connected
to the electrical supply.
Make sure that the fuse is the cause of
the malfunction. If the fuse is blown
again and again, contact a qualified
electrician.
Activate the hob again and set the
heat setting in less than 60 seconds.
Touch only one sensor field.
Refer to "Pause".
Clean the control panel.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
is on, press
ENGLISH
23
Advertisement
Table of Contents
