Table of Contents
Advertisement
E.6
Fitting anti-tipping cables on glass door
models (2 module) with feet or wheels
When installing the appliance, make sure to fix the anti-tipping
cables to it. To fit, proceed as follows:
1. undo the two Phillips screws securing the bracket to the
rear side on the roof of the machine, as shown in the
figure;
2. remove the cables from their packing;
3. join a slot of the cable to the screw;
3
4. retighten the screw complete with the cable on the roof of
the appliance;
5. the cable must then be fixed to the wall with a plug, to
permanently secure the appliance;
2
1
6. Repeat the same operation also with the other cable.
E.7
Plumbing connection
CAUTION
The plumbing connection must be carried
out by a specialised personnel.
The machine has a drain hole for any liquids present in the
compartment. Connect the compartment drain hole "D",
located on the bottom of the appliance and provided with a
closing plug, to a drain. The drain hole diameter is "17.5 mm",
therefore it is advisable to connect it to a "17.5 mm" drain pipe.
D
E.8
Reversing opening of fully insulated
doors
CAUTION
The user cannot reverse the door opening
direction in all models with glass door.
Models with glass door come with opening
from left to right. To reverse the opening
direction in refrigerated models, call the
Customer Care Service.
Single- door refrigerated cupboards are normally supplied with
right opening. When converting to left opening, proceed as
follows:
• open the control panel, loosening the 2 screws located
between the panel and door;
• undo the 2 fixing screws of bracket "A" and the screw
securing hinge "B" (detail 1);
• remove the door and remove hinge "B" from right to left,
break the precut "F" on the opposite side and insert part "B"
(detail 6) and the bracket as shown in the figure;
• remove the lower bracket "D", refitting it in the special seat
on the opposite side (detail 2);
• position the door on the lower bracket "D";
• position the upper bracket "A" between the door and the
roof of the appliance, tightening the fixing bolts;
• before tightening the screws, align the door with the panel of
the cabinet, adjusting the lower and upper brackets and
making sure the seal is perfectly fitted on all sides;
• then tighten the bracket fixing bolts.
29
Advertisement
Table of Contents
