Table of Contents
Advertisement
Polyethylene
• Outer wrapping
• Instructions bag
Polypropylene
• Straps
Polystyrene foam
• Corner protectors
The parts in wood and cardboard can be disposed of,
respecting the current regulations in the country where the
appliance is used.
E.5
Positioning
Install the appliance, taking all the safety precautions required
for this type of operation, also respecting the relevant fire-
prevention instructions.
If the machine is installed in a place where there are corrosive
substances (chlorine, etc.), it is advisable to go over all the
stainless steel surfaces with a rag soaked in paraffin oil to
create a protective film.
Arranging the machine:
• position the machine in the required place;
• adjust the height and levelling with the adjustment feet, also
checking correct door closing.
E.6
Fitting anti-tipping cables on glass door
models (2 module) with feet or wheels
When installing the appliance, make sure to fix the anti-tipping
cables to it. To fit, proceed as follows:
1. undo the two Phillips screws securing the bracket to the
rear side on the roof of the machine, as shown in the
figure;
2. remove the cables from their packing;
28
3. join a slot of the cable to the screw;
3
4. retighten the screw complete with the cable on the roof of
the appliance;
5. the cable must then be fixed to the wall with a plug, to
permanently secure the appliance;
6. Repeat the same operation also with the other cable.
E.7
Plumbing connection
CAUTION
The plumbing connection must be carried
out by a specialised personnel.
The machine has a drain hole for any liquids present in the
compartment. Connect the compartment drain hole "D",
located on the bottom of the appliance and provided with a
closing plug, to a drain. The drain hole diameter is "17.5 mm",
therefore it is advisable to connect it to a "17.5 mm" drain pipe.
D
E.8
Reversing opening of fully insulated
doors
CAUTION
The user cannot reverse the door opening
direction in all models with glass door.
Models with glass door come with opening
from left to right. To reverse the opening
direction in refrigerated models, call the
Customer Care Service.
Single- door refrigerated cupboards are normally supplied with
right opening. When converting to left opening, proceed as
follows:
• open the control panel, loosening the 2 screws located
between the panel and door;
2
1
Advertisement
Table of Contents
