Advertisement
6.6.
TO WASH WITH DETERGENT FIG.11
6.6.1.
Fill detergent bottle with a recommended detergent or cleaner with a water ratio according to instructions on the detergent.
Connect bottle to lance.
6.6.2.
Squeeze the wand trigger, detergent will come out through the nozzle. The adjustment knob on the detergent bottle will adjust the
concentration of detergent.
6.6.3.
Apply detergent so it thoroughly covers cleaning surface.
6.6.4.
Allow detergent to remain on the surface for a few minutes. Use a brush to lightly scrub heavily soiled areas.
6.6.5.
Change to spray nozzle, rinse detergent from surface.
6.6.6.
Cleaning up: Always draw fresh water through the detergent bottle when done to flush any remaining detergents from the injection
system. The bottle could be detached if necessary in this process.
fig.11
6.7.
PLACEMENT OF ACCESSORIES ON THE MACHINE FIG.12
6.7.1.
Gun, power lead, hose and accessories are placed as shown.
fig.12
7. MAINTENANCE
WARNING! Always disconnect from mains supply before carrying out any work on the appliance.
‰
Note: Any maintenance operations not covered by this chapter should be carried out by an properly qualified persons or the
manufacturer.
7.1.
CLEANING OF WATER INLET FILTER FIG.13
7.1.1.
The water filter installed inside the water inlet connector, should be cleaned periodically. Rinse it with clean tap water, and then place
it back into the water inlet connector.
7.2.
CLEANING THE NOZZLE FIG.14
7.2.1.
Using the nozzle tip cleaner provided (or an unfolded paper clip), insert the wire into the nozzle hole and move back and forth until
debris is dislodged. Back flush water through the nozzles using garden hose.
7.3.
CLEANING OF MACHINE VENTS
7.3.1.
The machine should be kept clean so as to let cooling air pass easily
through the machine vents.
7.4.
GREASE COUPLINGS
7.4.1.
To ensure easy connection and that o-rings work effectively, the couplings
should be greased regularly.
8. STORAGE
8.1.
Disconnect the water source, turn on the pressure washer for a few
seconds until the remaining water flows out, then turn it off quickly.
8.2.
Unplug the mains supply.
8.3.
Disconnect the high pressure hose and the garden hose, and coil high pressure hose for storage.
8.4.
Store in a frost free area with a temperature above 0°C.
© Jack Sealey Limited
fig.13
Original Language Version
fig.14
PW1860
Issue 1
17/11/2022
Advertisement
