Advertisement
5.7.
T.S. TOTAL STOP
NOTE:
Total Stop, which stops the machine during the bypass phase. To start the pressure washer, it is therefore necessary to set the switch
to the on position (I)"ON"; after that press the pistol trigger: the Total Stop will start the machine and will stop it automatically when
the trigger is released. It is advisable to put on the safety of the pistol trigger whenever the machine is stopped, in order to avoid
unintentional starting.
5.7.1.
Any automatic start of the machine without pressing the gun trigger is attributable to air bubbles in the water or other similar
phenomena which DO NOT imply the existence of any defects in the machine.
5.7.2.
DO NOT leave the appliance unattended during standby for more than 5 minutes. Contrarily, for the safety of the appliance it is
necessary to re-turn the switch into the (0) OFF position.
5.7.3.
Please check that the coupling of the high pressure hose with the appliance and the gun supplied as standard equipment made
correctly, that is to say without any water leak.
6. MAINTENANCE
6.1.
There are no user serviceable parts in this unit.
WARNING: the machine shall be disconnected from its power source, by removing the plug from the socket-outlet, during cleaning or
‰
maintenance
WARNING: DO NOT spray the appliance with water and DO NOT use detergents or aggressive solvents. Machine could be
‰
damaged.
6.2.
Clean the exterior part of the machine with a dry cloth.
7. STORAGE
7.1.
CLEAN AND DRY BEFORE STORING. SEE FIG. 13
7.1.1.
Move the machine only by grasping the carrying handle and using the wheels.
7.1.2.
Before storing clean the filter (fig.13.1), dry the hose (fig.13.2), and clean the nozzle (fig.13.3).
7.1.3.
Store the appliance and the accessories in a frost safe room (fig.13.4).
8. TROUBLESHOOTING
8.1.
APPLIANCE DOES NOT WORK
8.1.1.
Check whether the voltage shown on the rating plate corresponds to that of the power source.
8.1.2.
Check the connector cable for damage.
8.2.
APPLIANCE DOES NOT REACH OPERATIONAL PRESSURE
8.2.1.
Vent the appliance: allow the pump to operate without the high-pressure hose until water appears at the high-pressure outlet without
any more bubbles. Then reattach the high-pressure hose.
8.2.2.
Clean the strainer in the water connection (fig.13.1).
8.2.3.
Let the hose dry out (fig.13.2).
8.2.4.
Check the inlet water flow rate .
8.2.5.
Check all inlet pipes to the pump for leaks or blockage.
8.3.
STRONG PRESSURE FLUCTUATIONS
8.3.1.
Clean the high-pressure nozzle. Remove dirt from the nozzle hole with a needle and then rinse out with water from the front.
8.4.
PUMP LEAKS
8.4.1.
10 drops per minute are permissible. In the case of more serious leakage, you should contact the authorized customer service.
8.5.
REPLACEMENT PARTS
8.5.1.
Use only original spare parts or spare parts suggested by the manufacturer.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
fig.13
www.sealey.co.uk
PW1850 Issue 2 (2) 10/02/21
Advertisement
