Table of Contents
Advertisement
fig.10
6.5.
HOLDING THE GUN
6.5.1.
Hold the gun correctly to resist kickback force: one hand on the handle, one on the lance.
6.6.
TO WASH WITH DETERGENT FIG.11
6.6.1.
Fill bottle with a recommended detergent or cleaner with a water ratio according to instructions on the container. Connect nozzle to
lance.
fig.11
6.6.2.
Squeeze the wand trigger, detergent will come out through the nozzle.
6.6.3.
Apply detergent so it thoroughly covers cleaning surface.
6.6.4.
Allow detergent to remain on the surface for a few minutes. Use a brush to lightly scrub heavily soiled areas.
6.6.5.
Change to spray nozzle, Rinse detergent from surface.
6.6.6.
Cleaning up: Always draw fresh water through the detergent bottle when done to flush any remaining detergents from the injection
system. The bottle could be detached if necessary.
6.7.
PLACEMENT OF ACCESSORIES ON THE MACHINE FIG.12
6.7.1.
Gun, power lead, hose and accessories are placed as shown below.
fig.12
7. MAINTENANCE
WARNING! Always disconnect from mains supply before carrying out any work on the appliance.
‰
Note: Any maintenance operations not covered by this chapter should be carried out by an properly qualified persons or the
manufacturer.
7.1.
CLEANING OF WATER INLET FILTER FIG.13
7.1.1.
Water filter installed inside the water inlet connector, should be cleaned periodically. Rinse with clean tap water, and then place it
back into the water inlet connector.
7.2.
CLEANING THE NOZZLE FIG.14
7.2.1.
Using the nozzle tip cleaner provided (or an unfolded paper clip), insert the wire into the nozzle hole and move back and forth until
debris is dislodged. Back flush water through the nozzles using garden hose and highest pressure available (either standard water
nozzle or use your thumb over the nozzle to create water pressure for back flush.)
7.3.
CLEANING OF MACHINE VENTS
7.3.1.
The machine should be kept clean so as to let cooling air pass freely
through the machine vents.
7.4.
GREASE COUPLINGS
7.4.1.
To ensure easy connection and that o-rings work effectively, the couplings
should be greased regularly.
© Jack Sealey Limited
Original Language Version
fig.13
fig.14
PW1610
Issue 1
17/11/2022
Advertisement
Table of Contents
