Specifications - Microsensor MPM436W Operation Manual

Thanks for your using products from MICROSENSOR. MPM436W Lower
Range Submersible Level Transmitter is a full-sealed immersiable low range
capacitive transmitter. We suggest you to read this manual carefully before use.
1 Introduction
MPM436W Lower Range Submersible Level Transmitter uses high reliable and
tested ceramic capacitive sensor and special circuit, which is installed into a
stainless steel housing. With its integrated stainless steel full-sealed
construction, compact size, high stability, overpressure up to 80 times of FS and
good anti-corrosive. The MPM436W transmitter can be widely used for low
liquids level measurements and controls in the fields of petroleum,
chemi-industry, power factory, mine, city water supply etc.

2 Specifications

Pressure Range: 0...0.5 mH
Overpressure: 10×FS
Power Supply: 15V~28VDC
Output Signal: 4mA~20mADC(2-wire)
Load Resistor: R
Accuracy (including lin.+rep.+hys.): ±0.5%FS(min.) ±1.0%FS(max.)
Media Temperature: -30℃~+70℃
Storage Temperature:-30℃~+85℃
Protection:IP68
Materials contact with media:
O~0...2mH
2
≤((U-15V)/20mA)-Rwire(kΩ)
L
U=power supply, Rwire=wire resistor value
O
2
15V～28VDC
0V~5VDC(3-wire)
1
＞5kΩ