Figure 3-2: "Set Up System Configuration" Screen - Epson Apex 286/12 User Manual

1. Setting Up System Configuration
If you choose item 1 from the screen on the previous page to configure
your system, the following will appear:
ROM SETUP PROGRAM VERSION 2.0
(C) COPYRIGHT DATATECH ENTERPRISES CO., LTD 1990.
ALL RIGHTS RESERVED.
SET UP SYSTEM CONFIGURATION
1. CURRENT DATE : [04-26-1990]
2. CURRENT TIME : [05:30:00]
3. COPROCESSOR : [ 1 ]
4. BASE MEMORY :[ 640 KB ]
5. EXTENDED MEMORY : [ 1280 KB ]
6. DISKETTE DRIVE A : [ 1.2 M ]
DISKETTE DRIVE B : [ NO ]
7. FIXED DISK TYPE C : [ 40 / MFM ]
FIXED DISK TYPE D : [ NO / NONE ]
8. PRIMARY DISPLAY CARD : [ MGA ]
9. EXIT
CHOOSE ITEM NUMBER : [l]
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
›œ ›œ :CHANGE ITEM
Figure 3-2: "Set Up System Configuration " Screen
Once you have entered all appropriate information and exited by
choosing item 9, you will be asked to confirm that the configuration
data are correct.
If at a later date you alter the configuration of your system, you will
need to go through the program again and make the appropriate
changes.
•ž :MODIFY •ž 8 8
:ACCEPT
Chapter 3: Operating Your System 15