Table of Contents
Advertisement
Downloading a BIOS update
CAUTION:
installation, download and install a BIOS update only when the computer is connected to reliable
external power using the AC adapter. Do not download or install a BIOS update while the computer is
running on battery power, docked in an optional docking device, or connected to an optional power
source. During the download and installation, follow these instructions:
Do not disconnect power from the computer by unplugging the power cord from the AC outlet.
Do not shut down the computer or initiate Sleep.
Do not insert, remove, connect, or disconnect any device, cable, or cord.
1.
From the Start screen, select the HP Support Assistant app.
2.
Select Updates and tune-ups, and then select Check for HP updates now.
3.
Follow the on-screen instructions.
4.
At the download area, follow these steps:
a.
Identify the most recent BIOS update and compare it to the BIOS version currently installed
on your computer. Make a note of the date, name, or other identifier. You may need this
information to locate the update later, after it has been downloaded to your hard drive.
b.
Follow the on-screen instructions to download your selection to the hard drive.
If the update is more recent than your BIOS, make a note of the path to the location on your
hard drive where the BIOS update is downloaded. You will need to access this path when
you are ready to install the update.
NOTE:
before installing any software updates, especially system BIOS updates.
BIOS installation procedures vary. Follow any instructions that are displayed on the screen after the
download is complete. If no instructions are displayed, follow these steps:
1.
From the Start screen, type e, and then select File Explorer.
2.
Click your hard drive designation. The hard drive designation is typically Local Disk (C:).
3.
Using the hard drive path you recorded earlier, open the folder on your hard drive that contains
the update.
4.
Double-click the file that has an .exe extension (for example, filename.exe). The BIOS
installation begins.
5.
Complete the installation by following the on-screen instructions.
NOTE:
After a message on the screen reports a successful installation, you can delete the
downloaded file from your hard drive.
Using System Diagnostics
System Diagnostics allows you to run diagnostic tests to determine if the computer hardware is
functioning properly.
To start System Diagnostics:
1.
Turn on or restart the computer, quickly press esc, and then press f2.
2.
Click the diagnostic test you want to run, and then follow the on-screen instructions.
72
Chapter 5 Using Setup Utility (BIOS) and System Diagnostics
This manual downloaded from http://www.manualowl.com
CAUTION: To reduce the risk of damage to the computer or an unsuccessful
If you connect your computer to a network, consult the network administrator
Advertisement
Table of Contents
