Table of Contents
Advertisement
Remove the fan/heat sink assembly:
1.
Turn the system board upside down, with the front toward you.
2.
Disconnect the fan cable (1) from the system board.
3.
Remove the Phillips PM2.0×3.5 screw (2) that secures the fan/heat sink assembly to the
system board.
4.
Following the 1, 2, 3, 4 sequence stamped into the fan/heat sink assembly, loosen the four
captive Phillips screws (3) that secure the fan/heat sink assembly to the system board.
This manual downloaded from http://www.manualowl.com
Component replacement procedures
57
Advertisement
Table of Contents
