Steps
1. Remove the four screws (M2.5x4) that secure the left and right display hinge to the bottom side of the palm-rest and keyboard
assembly.
2. Remove the two screws (M2x2.5) that secures the display-cable bracket to the palm-rest and keyboard assembly.
3. Lift the display-cable bracket off the palm-rest and keyboard assembly.
4. Disconnect the microSD-card reader cable from the system board.
5. Disconnect the display cable from the system board.
6. Turn the computer over.
7. Remove the four screws (M1.6x3) that secures the display-cable holder to the palm-rest and keyboard assembly.
8. Lift the display-cable holder and rotate the display-cable holder to 180 degrees so that the microSD-card reader is visible.
9. Remove the screw (M1.6x3) that secure the microSD-card reader to the display-cable holder.
10. Remove the microSD-card reader from the display-cable holder.
11. Slide and remove the display-cable holder off the palm-rest and keyboard assembly.
NOTE: While removing the display cable from the display cable holder, push open the spring-loaded bar separating the two
slits in the middle of the display holder.
12. Route the display cable from the slot between the palm-rest and keyboard assembly and rear I/O cover.
46