Transporting Sensitive Components; After Working Inside Your Computer - Dell Alienware x16 R1 Service Manual

Hide thumbs Also See for Alienware x16 R1:

Setup and specifications (23 pages)

Table of Contents

best method for doing this test. If you do not have your own wrist strap tester, check with your regional office to find out if they

have one. To perform the test, plug the wrist-strap's bonding-wire into the tester while it is strapped to your wrist and push the

button to test. A green LED is lit if the test is successful; a red LED is lit and an alarm sounds if the test fails.

● Insulator Elements – It is critical to keep ESD sensitive devices, such as plastic heat sink casings, away from internal parts that are

insulators and often highly charged.

● Working Environment – Before deploying the ESD Field Service kit, assess the situation at the customer location. For example,

deploying the kit for a server environment is different than for a desktop or portable environment. Servers are typically installed

in a rack within a data center; desktops or portables are typically placed on office desks or cubicles. Always look for a large open

flat work area that is free of clutter and large enough to deploy the ESD kit with additional space to accommodate the type of

system that is being repaired. The workspace should also be free of insulators that can cause an ESD event. On the work area,

insulators such as Styrofoam and other plastics should always be moved at least 12 inches or 30 centimeters away from sensitive

parts before physically handling any hardware components

● ESD Packaging – All ESD-sensitive devices must be shipped and received in static-safe packaging. Metal, static-shielded bags

are preferred. However, you should always return the damaged part using the same ESD bag and packaging that the new part

arrived in. The ESD bag should be folded over and taped shut and all the same foam packing material should be used in the

original box that the new part arrived in. ESD-sensitive devices should be removed from packaging only at an ESD-protected

work surface, and parts should never be placed on top of the ESD bag because only the inside of the bag is shielded. Always

place parts in your hand, on the ESD mat, in the system, or inside an anti-static bag.

● Transporting Sensitive Components – When transporting ESD sensitive components such as replacement parts or parts to be

returned to Dell, it is critical to place these parts in anti-static bags for safe transport.

ESD protection summary

It is recommended to use the traditional wired ESD grounding wrist strap and protective anti-static mat at all times when servicing

Dell products. In addition, it is critical to keep sensitive parts separate from all insulator parts while performing service and that they

use anti-static bags for transporting sensitive components.