Replacing The Lamp - Epson PowerLite Pro Cinema 7100 User Manual

Replacing the Lamp

The projection lamp lasts for up to 4000 hours. You can use the
long it's been in use (see page 53). It's time to replace the lamp when:
■
The projected image gets darker or starts to deteriorate.
■
The projector's lamp light flashes red at half-second
intervals.
■
The message
when you start projecting.
Note: Lamp life results will vary depending on mode selected,
environmental conditions, and usage.
Turn off this product when not in use to prolong the life of the projector.
You can purchase lamp part number V13H010L49 (ELPLP49) from an authorized Epson
reseller. To find the nearest reseller, please call 800-GO-EPSON (800-463-7766). To
purchase online, visit www.epsonstore.com (U.S. sales) or www.epson.ca (Canadian sales).
Be sure to read the "Important Safety Information" on page 69 before replacing the lamp.
Warning: Let the lamp cool fully (about 1 hour) before replacing it. In the unlikely event that the
lamp has broken, small glass fragments may be present and should be removed carefully to avoid
injury.
Caution: Never touch the glass portion of the lamp with your bare hands; the invisible residue left
by the oil on your hands may shorten the lamp life. Use a cloth or glove to handle the new lamp.
Follow these steps to replace the lamp:
1. If the projector is on, press the P
2. Turn off the power switch on the back of the projector.
3. Unplug the power cord and any cables.
4. Wait about an hour to make sure the lamp is no longer hot.
50
Maintenance
appears on the screen
Replace the lamp
Power
Info
Lamp
light
button and wait for the light to stop flashing.
menu to check how