Installing The Display Assembly - Dell Inspiron 14 7435 2-in-1 Owner's Manual

Steps
1. Peel the tape that secures the display-cable connector latch to the system board.
2. Lift the latch and disconnect the display cable from the connector on the system board.
3. Lift the latch and disconnect the touch-screen cable from the connector on the system board.
4. Open the display and place the computer on a clean and flat surface.
5. Remove the two screws (M2.5x4) that secure the left display hinge to the palm-rest and keyboard assembly.
6. Remove the three screws (M2.5x4) and the screw (M2x4) that secure the right display hinge to the palm-rest and keyboard
assembly.
7. Gently lift the display assembly off the palm-rest and keyboard assembly.

Installing the display assembly

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs) 65