Removing the M.2 2280 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE:
This procedure applies only to computers shipped with an M.2 2280 solid-state drive installed.
NOTE:
The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on
the M.2 card slot:
● M.2 2230 solid-state drive + M.2 2230 solid-state drive mounting bracket
● M.2 2280 solid-state drive
The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2x3) that secures the solid-state drive to the palm-rest and keyboard assembly.
2. Slide and lift the M.2 2280 solid-state drive off the system board.
Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
This procedure applies if you are installing a M.2 2280 solid-state drive.
NOTE:
The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on
the M.2 card slot:
40
Removing and installing Customer Replaceable Units (CRUs)
Before working inside your
computer.