RAB W17-30L Instructions

INSTRUCTIONS
W17 WALL PACK INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We'd love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
W17-30L/36L
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING:
• Make certain power is OFF before installing or maintaining fixture.
NOTE:
• No user maintenance or cleaning required.
MOUNTING FIXTURE TO THE WALL
Fixture should not be recessed, surface mount only.
1. Open Reflector Door by loosening Reflector Door Screw (1),
see Fig. 1.
2. Reflector Door eflector Door will hinge downward and remain attached
will hinge downward and remain attached
during installation as shown in Fig 2 during installation as shown in
3. 3. Line up the Fixture Fixture to desired location. Use the to desired location. Use the Drill Template
Line up the
(Fig. 2) (Fig. 2) on the inside back surface of the on the inside back surface of the Fixture
most standard junction boxes. most standard junction boxes. Secure the
screws screws (supplied by others) (supplied by others). .
4. 4.
Complete the wiring to the supply wires and ground (see wiring Complete the wiring to the supply wires and ground
instructions Fig. 3 Fig. 3) ) . .
instructions
5. 5. Pivot the Reflector Pivot the Reflector Door Door back into place and push until it snaps
closed. Tighten closed. Tighten Reflector Door Screw Reflector Door Screw (1) to secure
Door to Fixture.
6.
Apply weatherproof silicone sealant around the edge of the wall
box. This is especially important with an uneven wall surface.
Fig 2. .
Drill Template
Fixture to match
to match
Secure the Fixture Fixture in place with in place with
back into place and push until it snaps
(1) to secure Reflector
W17-55L/75L/90L
FIG. 1
Reflector
(see wiring
FIG. 2
Drill Plate
Mounting Screws (4)
(supplied by others)
Reflector
Door
W17-150L
Fixture
Reflector Door
Screw