Advertisement
Quick Links
Q U I C K S T A R T
B 40 C Bp
Start up
1
A
2
A
Warning
These are only brief instructions! Please read and comply with these instructions prior to using or servicing your
appliance.
The non-compliance of the operating and safety instructions may lead to damage of the appliance and to risks for
the operator and other persons.
B
B
A Unplug the charger from the mains.
B Coil the battery charging cable around the ca-
ble hooks.
A Open the lock of the fresh water reservoir.
Fill fresh water (maximum 60 °C) until the
lower edge of the filling nozzle.
Close the lock of the fresh water reservoir.
or
B Connect the hose to the automatic filling sys-
tem and open the water supply (max. 60 °C,
max. 5 bars).
Monitor the appliance - the automatic filling
system will interrupt the water supply when
the tank is full.
Shut off the water supply and disconnect the
hose from the appliance.
Warning
Risk of damage. Only use the recommended de-
tergents. With respect to different detergents the
operator bears the increased risk regarding the
operational safety and danger of accident.
Only use detergents that are free from solvents,
hydrochloric acid and hydrofluoric acid.
Follow the safety instructions for using deter-
gents.
Note
Do not use highly foaming detergents.
C Add the detergent to the fresh water reser-
voir.
5.965-085.0 07/13
Advertisement
Related Manuals for Kärcher B 40 C Bp
Summary of Contents for Kärcher B 40 C Bp
- Page 1 Q U I C K S T A R T B 40 C Bp Warning These are only brief instructions! Please read and comply with these instructions prior to using or servicing your appliance. The non-compliance of the operating and safety instructions may lead to damage of the appliance and to risks for the operator and other persons.
-
Page 2: Operation
Q U I C K S T A R T Operation Setting the water quantity A Adjust the water quantity using the regulating button according to the dirt on the floor cover- ing. Lower the cleaning head A Press the pedal for lowering the cleaning head downwards slightly and then move it to the left. -
Page 3: Finish Operation
Q U I C K S T A R T Finish operation Shutting Down the Appliance A Close the regulatory button for setting the wa- ter quantity. B Set the program selection switch to suction or vacuuming. Drive the appliance forward for another 1-2 m to draw off residual water. -
Page 4: Maintenance And Care
Q U I C K S T A R T Finish operation Empty waste container (only with R cleaning head) A Remove bulk waste container and empty it. Charging battery A Charge the battery if required. Maintenance and care Warning Risk of damage. - Page 5 Q U I C K S T A R T Maintenance and care A Clean the vacuum lips and the wip- ing lips, check for wear and replace if required. B Clean the suction channel. A Clean brush. Check the brushes for wear, re- place if required.