Restoring Factory Settings; Maintenance And Cleaning; Technical Specifications - HomeMatic HmIP-P-DRG-DALI Installation And Operating Manual

8

Restoring factory settings

The device's factory settings can be restored. If you do this, you will
lose all your settings.
To restore the factory settings of the device, please proceed as follows:
Press and hold down the system button (A) for 4 seconds until
•
the LED (A) quickly starts flashing orange (see figure 12).
• Release the system button.
• Press and hold down the system button again for 4 seconds, until
the LED lights up green (see figure 13).
• Release the system button again to complete restoration of the
factory settings. The device will perform a restart.
9

Maintenance and cleaning

The product does not require any maintenance. Leave any mainte-
nance or repair to a specialist.
The mains voltage must be disconnected before the device is re-
moved (trip the miniature circuit-breaker). Only qualified electricians
(to VDE 0100) are permitted to carry out work on the 230 V mains.
Clean the device using a soft, clean, dry and lint-free cloth. Do not use
any detergents containing solvents, as they could corrode the plastic
housing and label.
10

Technical specifications

Device short description:
Supply voltage:
Current consumption:
Power consumption
Standby:
Cable type and cross section: rigid and flexible cable
HmIP-P-DRG-DALI
230 V~/50 Hz
45 mA max.
1 W typ. (display lighting off)
0.75-2.5 mm²
Restoring factory settings
41