Integration Into Network (Lan); Restoring The Factory Settings - HomeMatic HMW-LGW-O-DR-GS-EU Installation And Operating Manual

7

Integration into network (LAN)

To establish communication between your HomeMa-
tic Central Control Unit and the HomeMatic Wired
devices, the HomeMatic RS485 Gateway has to be
integrated into the network. To do this, proceed as
follows:
Configuration via HomeMatic Central Control Unit
• Open the „WebUI" user interface in your browser.
• In the WebUI, please click „Settings"
control" „LAN Gateway Settings".
• In the next window under „General settings", please
click on „Add".
• In the next window, select the type „Wired: Home-
Matic Wired RS485 Gateway". Afterwards, enter the
serial number (see sticker on the top of your gate-
way) and the security key/password (see sticker
on the buttom of your gateway) of your HomeMatic
Wired RS485 Gateway. You can change your set-
tings again later.
• Please confirm with „OK" and in the next window
with „Save".
• Afterwards, restart your HomeMatic Central Control
Unit.
• The Gateway has been integrated successfully into
50
„System
8
The factory settings of the HomeMatic RS485 Gate-
way can be restored manually. If you do this, you will
lose all your settings.
To restore the factory settings, please proceed as
follows:
• Press the reset button for approx. 6 seconds. The
the network if the status is „Connected".
To integrate single HomeMatic Wired devices
into your system, please proceed as described
in the corresponding operating manuals.
Further information about network problems
(e.g. no DHCP) can be found in the FAQs of
the website www.homematic.com.

Restoring the factory settings

Before restoring the factory settings, please
delete the device from the user interface WebUI
first.
quickly flashing LED indicates „delete mode".
51