Fast Moving Targets And Sart; Optimization For Sart Display - ProNav JMR-5410-4X User Manual

1.4 Fast moving targets and SART

Procedure for detecting moving echoes
The radar has a feature for improving the detection of fast-moving radar echoes.
 Fast Target Detection See menu under
MENY + Setting
Setting meny
Echo
Signal process

1.5 Optimization for SART display

To optimize the echo display from the SART transponder, the SART mode must be turned on.
Select scale to 6 or 12 miles, then select Delicate  See menu above
If the function is not used, SART echoes will be displayed but they will be weaker in strength.
JMR-5400 User Manual 20201214 temp
Undermeny
Video Latitude
Video Noise Rejection
 Auto Dynamic Rng Kontroll
Process Switch
Process Switch
2nd Proc mode
Process Switch Range
 Fast Target Detection
 SART
Oppsett
Normal
Level1(low)
Off

Remain 
3.0 NM 
If there are fast targets that are not
displayed well enough, you can select
Fast target and the targets will then be
displayed at full strength at the first
swipe.
SART is used if SART signals are weak and
occasionally filtered out as noise..
Indication that the SART function is active can be
found in the lower left corner where the tune info is
Select both Fast Target Detection and SART on.
12
Receiver Band Width
Noise control / processing
Auto Dyn. control, for
automatic distance, but
you can select different
processing types at short
and long distances as well
as the distance where the
shift is