Husqvarna Z560LS Operator's Manual page 24

Grease nipple
A B
A C
Refer to Lubrication
Lubricate the grease nipple on
A
the pivot axle with a grease gun.
Lubricate the grease nipple on
B
the wheel axle with a grease gun.
Lubricate the grease nipples on
C
each spindle with a grease gun.
Lubricate the grease nipple on
D
the cutting deck idler arm.
Always use good quality grease. Always use
recommended oil, refer to
28 .
To lubricate the front wheels
• Remove the dust cap (A). Grease the nipple (B)
with a grease gun until grease comes out from
the top washer.
A
C
Tightening torques
Engine crankshaft bolt
Mandrel pulley nuts
Idler pulley nuts
Idler arm bushing nut
Lug nuts
24
A A
A B
A C
A C
D D
Technical data on page
B
• Lubricate the joint bearing of the front wheels (C)
with a grease gun until grease comes out.
To lubricate the cutting deck
spindles
1. Remove the footrest plate (A).
2. Lubricate the 3 cutting deck spindles (B) 2-3
strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
3. Lubricate the idler arm (C) 2-3 strokes.
50 ft-lb / 68 Nm
17 ft-lb / 23 Nm
30 ft-lb / 40.6 Nm
70 ft-lb / 95 Nm
75 ft-lb / 102 Nm
A
C
B
2060 - 001 - 07.02.2023