Husqvarna Z560LS Operator's Manual page 14

5. Move the throttle lever (A) to ½ throttle position.
A
B
6. Turn the fuel tank valve to select 1 of the 2 fuel
tanks.
7. Set the cutting height. Refer to
height on page 13 .
8. Press and turn the ignition key to the start
position (B).
9. When the engine starts, immediately release the
ignition key to the run position.
Note:
Do not keep the ignition key in the start
position for more than 5 seconds at a time. If the
engine does not start, wait 15 seconds before
you try again.
10. Let the engine run at ½ throttle for 3-5 minutes
before you apply full throttle.
11. Push the throttle control to the full throttle
position.
To operate the product
1. Start the engine. Refer to
page 13 .
2. Disengage the parking brake. Refer to
engage and disengage the parking brake on
page 12 .
3. Carefully push the 2 control levers forward. The
product will start to move forward. The forward
speed increases the more the 2 control levers
are pushed forward.
4. Carefully pull the 2 control levers rearward. The
product will start to move rearward. The rearward
speed increases the more the 2 control levers
are pulled rearward.
14
To set the cutting
To start the engine on
To
5. Put the 2 control levers in neutral position to
decrease the speed and stop the product.
6. Do the steps that follow to turn left or right when
you go in a forward direction.
a) Pull the left control lever rearward in the
direction of the neutral position to make the
product turn left. The more you pull the left
control lever rearward, the more the product
will turn left.
b) Pull the right control lever rearward in the
direction of the neutral position to make the
product turn right. The more you pull the right
control lever rearward, the more the product
will turn right.
7. Do the steps that follow to make a zero turn.
a) Pull the 2 control levers rearward in the
direction of the neutral position to decrease
the speed or stop the product.
b) Move 1 control lever slightly forward and the
other control lever slightly rearward to make a
zero turn.
8. Lower the cutting deck to mow position. Refer to
To set the cutting deck in transport position or
mow position on page 13 .
9. Pull up the PTO button to engage the drive of the
blades.
10. If it is necessary to adjust the cutting height
during operation, refer to
height on page 13 .
To stop the engine
1. Move the 2 control levers to the neutral position
to stop the product.
2. Engage the parking brake.
To set the cutting
2060 - 001 - 07.02.2023