Sending Information To Your Printer - Epson ActionPrinter 4000X User Manual

You have seen how to design a character by placing dots on a grid
and translating the dots to decimal equivalents. The last step in
defining a character is sending this information to your printer.

Sending Information to Your Printer

The printer loads characters in the print style (Letter Quality, draft,
or proportional) that the printer is currently using. It also records
whether italic, superscript, or subscript is turned on. This means that
if you want to print a character in italics, for example, you must have
the italic mode turned on when you define the character.
The command your printer uses to define characters is one of the
most complex in its repertoire. The format of the command is this:
The ESC & is simple enough. The 0 allows for future enhancements.
At this time, it is always ASCII 0.
You can define many characters with a single command. The values
n1 and n2 are the ASCII codes of the first and last characters you are
defining. If you are defining only
same. You can use any codes between decimal 32 and 127 for n1 and
n2, but it is best not to define decimal 32, which is the code for a
space. Also, you can use letters in quotation marks instead of ASCII
codes for and
n1
Note: Because user-defined characters require additional memory,
you must set DIP switch 2-5 to 1 KB (off) before downloading
these characters.
ESC & 0 n1 n2 d0 d1 d2 data
n2.
character, n1 and n2 are the
one
Software and Graphics
User-defined Characters
4-21