Advertisement
Step 2
NOTE: Before beginning this step, separate the SLIDES from
å
the SLIDE SETS (16B) and the DRAWER PINS at the end of the
SLIDES using a SCISSORS. Save the DRAWER PINS. You will use
them in Step 13.
Fasten the SLIDES (16B) to the RIGHT END (A) and UPRIGHT (C).
å
Use twelve SILVER 3/4" PAN HEAD SCREWS (52S) through the
fi rst and last holes in the SLIDES.
NOTE: The SLIDES are marked "RIGHT" and "LEFT" for easy
å
identifi cation. The SLIDES marked "RIGHT" will fasten to the
RIGHT END (A) and the SLIDES marked "LEFT" will fasten to the
UPRIGHT (C). There are also arrows on the SLIDES for correct
positioning on the ENDS.
Notch
Straight edge
16B
LEFT SLIDES
Finished edge
DRAWER PIN
(Save for Step 13)
Page 6
16B
C
16B
Using your Scissors, separate the SLIDES and the DRAWER PINS
SILVER 3/4" PAN HEAD SCREW
Finished edge
16B
16B
Angled edge
16B
416350
52S
(12 used in this step)
RIGHT SLIDES
A
16B
www.sauder.com/services
Advertisement
