Advertisement
Step 8
Carefully stand your unit upright.
å
Fasten two HINGES (14H) to a DOOR (G). Use four
å
BLACK 1/2" FLAT HEAD SCREWS (11S).
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (G) to the LEFT END (B). Use the screws
å
in the HINGES. See the next step for door adjustments.
Fasten a PULL (45K) to the DOOR (G). Use two SILVER
å
7/8" MACHINE SCREWS (24S).
Repeat this step for the other DOOR (G).
å
45K
Stop
Mounting
screw
Hinge
Page 12
B
G
24S
SILVER 7/8" MACHINE SCREW
(4 used for the PULLS)
416350
11S
BLACK 1/2" FLAT HEAD SCREW
(8 used for the HINGES)
14H
G
www.sauder.com/services
Advertisement
