Assembly; Operation - Husqvarna HA200 Operator's Manual

• Always wear heavy-duty gloves when repairing the
cutting attachment. This is extremely sharp and can
easily cause cuts.
To install the handguard (HA200) (only
for gasoline operated products)
1. Install the handguard with the screw and the knob .
To install the harness support hook
(HA860)
1. Remove the screw to release the holder of the
harness support hook.
To do before you operate the product
• Examine the work area and remove loose objects.
• Do a check of the cutting unit. Refer to
check of the blades on page 21 .
• Make sure that the gear housing is correctly
lubricated.
• Make sure that the safety devices of the product
operates correctly. Do not use the product without all
safety devices installed correctly.
• Make sure that all screws and nuts are tight.
• Make sure that all covers are attached correctly and
not damaged before you start the product.
• Make sure that the cutting unit stops when the
engine is at idle speed.
22
• Store the product out of reach of children.
• Use only original spare parts for repairs.

Assembly

2. Put the harness support hook between the throttle
handle and the loop handle.
3. Install the screw to attach the harness support hook.
4. Adjust the position of the harness support hook until
the product is balanced and easy to use.

Operation

To do a check before start
1. Examine the work area. Remove any objects that
could be thrown out.
To do a
2. Examine the cutting attachment. Do not use blades
that are damaged.
3. Examine that the product is in perfect working order.
Examine that all nuts and screws are tight.
4. Make sure the gear housing is lubricated correctly.
See
page 25 for instructions.
5. Examine that the cutting attachment stops when the
throttle/power trigger is released.
6. Only use the product for the purpose it was intended
for.
To lubricate the bevel gear and gearbox on
1183 - 002 - 16.01.2023