Husqvarna HVT40 Operator's Manual

READ THESE INSTRUCTIONS
CAREFULLY!
KNOW YOUR CONTROLS.
LEARN HOW TO STOP YOUR
TRIMMER IN AN EMERGENCY
Upper Handle
Bolt, washer
and Lock nut
Lower Handle
Tank Cap
Starting Handle
Debris Guard
Deck
Spark Plug/Lead
PREPARATION
Before using your new Husqvarna Hover
Trimmer, make a careful note of the
details on the serial number label, which
can be found on the rear of the deck.
Always quote these details to your dealer
when enquiring about spares and
service.
AIR CUSHION GASOLINE TRIMMER
OPERATOR MANUAL
ASSEMBLY OF LOWER
HANDLE TO DECK
With the trimmer on the ground:
1. Remove the bolts (1), washers (2) and
lock nuts (3) from the polythene bag.
2. Place one washer (2) on to the bolt (1)
and secure the lower handle (4) by
placing bolts (1) through deck brackets
(5) and lower handle (4).
3. Place washer (2) on bolt and secure
with lock nut (3).
3
2
Start/Stop
Switch
ASSEMBLY OF UPPER
HANDLE TO LOWER HANDLE
Tie
wraps
Assemble upper handle (6) to lower
handle (7) by fitting bolts (8) and washers
(9) and securing with lock nuts (10).
Air Cleaner
7
8
Bolt,
washer
and
Lock nut
HANDLE POSITION
The handle position can be altered by
moving it forward for the park position or
back for the trimming position.
Primer
Park Position
Trimming Position
4
2
1
5
CARRYING THE TRIMMER
6
9
10
NOTE:
Before carrying the machine from one
trimming area to another, disconnect the
spark plug lead.
Carry the trimmer at the point of balance
(see illustration) with the cutting head
away from you.
NEVER CARRY THE TRIMMER WHEN
IT IS RUNNING.
5118384-02
HVT40