Replacing Ribbon Cartridge - Pyramid Smart Site 3500ss User Manual

SMART SITE™ TIME CLOCK & DOCUMENT STAMP
Model 3500ss/3600ss/3700HDss

REPLACING RIBBON CARTRIDGE

1
Unlock and remove cover.
p
2 (UP) for 3 seconds to park ribbon carriage (Clock has to dispaly TIME).
Press
Unplug power to time clock *IMPORTANT*.
3
4 Turn clock on its side so ribbon cartridge & holder are on top.
5
Slide actuator to far left and out of the way which is located underneath the
clock. (see diagram).
6
Remove old ribbon cartridge by holding tab and lifting up.
7
Snap in new ribbon cartridge between printer head and mylar.
8
Turn the knob, follow arrow to stretch the ribbon. It will turn easily.
9
Replace cover, lock unit & plug in.
10
Feed time card through unit to test print quality.
11
Readjust the actuator.
Ribbon tabs
Ribbon clips
Printer head
Mylar
If ribbon is not completely over print head the resulting print will show incomplete
characters. If ribbon cartridge is not completely snapped in holder, the resulting print
will be increasingly lighter.
pyramidtimesystems.com
Knob
REPLACING RIBBON CARTRIDGE
Slide actuator
far right and out
of the way (located
underneath the unit)
13