Jeep Phoenix User Manual page 19

4
7
8
10
11
17
18
19
20
Parameter configuration
Press the M button for approximately 3 seconds to enter the set-up menu; press the M button for approximately 3 seconds to
exit the set-up menu and confirm the entered parameters.
Select the desired value of the individual parameter by pressing the + or – buttons and confirm it by pressing the M button
(quickly to access the next configurable parameter, or for approximately 3 seconds to exit the configuration menu by con-
firming the entered parameters.).
The sequence of parameters that can be configured is shown below:
P1 - Unit of measurement:
Press the + or – buttons to select the unit of measurement for the speed and travel data displayed on the display:
International metric system (Km/h and Km) or British imperial system (MPH and Mile)
P2 - User password ON/OFF display:
Available options = on / off
OFF = selecting "off", confirmed by pressing the M button, excludes the user password request (identification code) to allow
the user to access and activate the display and allow full control of all the functions provided for the electrically power
assisted cycle.
The display controls and functions will be immediately accessible after pressing the ON button.
ON = by selecting the data "on", confirmed by pressing the M button, the configuration parameter is enabled which provides
for the activation of the display and access to all the functions provided for the complete management of the pedal-assisted
bicycle exclusively after entering a user password (identification code).
Display controls and functions, after pressing the ON button, will only be accessible after entering the user password
previously set (P3).
P3 - User password:
Parameter only displayed after the "ON" option has been selected, which allows the user to enable the display access
configuration exclusively by entering the password (numeric identification code consisting of 4 digits) previously set and
confirmed as follows:
select the 4 digits which make up the password by pressing the + and – buttons and confirm them individually by
-
pressing the ON/OFF button
confirm the 4-digit numeric identification code by pressing the M button for approximately 3 seconds to exit the configu-
-
ration menu, confirming the entered parameters.
0000 - System parameter setting password only accessible to after-sales service
If incorrect data on the speed (Km/h and Km) and distance (MPH and Mile) are shown on the display, contact the after-sales
technical support service for assistance: www.jeepurbanemobility.com/supporto/
Control unit malfunction
Control unit overheating
High voltage protection (voltage above threshold)
Motor malfunction (excessive power consumption)
Motor hall sensor malfunction
Display-control unit wiring communication malfunction
Display-control unit programming communication malfunction
Brake sensor malfunction
Motor block
18