Jeep Phoenix User Manual page 13

Positioning the handlebars
Position the handlebars on the handlebar attachment taking care to centre and adjust them correctly so they slot onto the
controls, tightening the handlebar attachment lever (tightening device between the handlebars and handlebar attachment).
Handlebar attachment plate assembly/disassembly instructions for handlebar installation/removal (if necessary)
From the upper end of the handlebar stem
Remove the handlebar attachment plate as
follows:
Remove screw number 1 and then
lever number 2.
Then proceed to remove the metallic plate
number 3 and finally remove metallic plate
number 4 making it slide sideways.
Proceed to reassemble the previously
removed
handlebar attachment plate in the
reverse sequence.
Make sure to tighten it correctly to avoid
the occurrence of dangerous situations
during
the ride.
12