Rear Panel - Yamaha CK88 Owner's Manual

Panel controls

Rear panel

1
AC adaptor
AC outlet
1 [DC IN] jack (page 20)
For connecting the included AC adaptor.
2 [P] (STANDBY/ON) switch (page 22)
For switching the CK to standby (N) or turning it
on (O).
3 OUTPUT jacks
Standard phone (unbalanced) jacks for outputting
audio signals. For output in mono, connect only to the
[L/MONO] jack.
4 A/D INPUT jacks
Standard phone jacks (1/4" mono phone plug) for
receiving audio from the external audio device.
Musical instruments such as synthesizers, audio
devices, such as portable music players, as well as
dynamic microphones can be connected to these
jacks, and the audio input signals can be played as an
audio Part. In addition, the effects can be applied to
external audio signals. The effect type can be set from
the [INPUT] button.
To switch the input source (to Line or MIC), use the
[MENU] button  General  Audio  A/D Input Type.
NOTE
The CK does not support phantom-powered condenser
microphones.
5 A/D INPUT [GAIN] knob
The external audio source input via these jacks is
mixed in with the sounds played by the CK. Use this
knob to adjust the balance between the external audio
and the CK sounds.
18
CK88 CK61 Owner's Manual
2
3
Keyboard amplifier External
or synthesizer
Monitor speakers
Dynamic mic
6 FOOT PEDAL jacks
For connecting a separately sold sustain pedal. The
compatible pedals are Foot Pedal FC3A, Footswitch
FC4A, Footswitch FC5, and Foot Controller FC7.
Set the pedal type from the [MENU] button  General
 Foot Pedal.
NOTE
When the pedal connected to the jack and the Foot Pedal setting do
not match, the pedal may not work properly or may malfunction.
Make sure to select the correct pedal type for the pedal connected
to the jack.
You can assign functions such as sustain or sostenuto
from the [SETTINGS] button  Controllers  Foot
Pedal 1 or Foot Pedal 2  Assign (page 31).
7 SPEAKERS switch
For tuning the built-in speakers on or off.
If this switch is on and the Speaker Mute is set to Auto,
the built-in speakers will automatically be muted when
the headphones are connected.
To change the Speaker Mute setting, set from the
[MENU] button  General  System  Speaker 
Speaker Mute.
4 5 6
FC7 FC5
FC3A,
FC4A