Parts And Components; Before Use; Operation - cecotec POWER ESPRESSO 20 BARISTA CREAM Instruction Manual

ENGLISH

1. PARTS AND COMPONENTS

Img. 1
1. Double espresso filter
2. Cleaning brush
3. Cleaning pin
4. Accessory box
5. Steam dial
6. Buttons
7. Filter for 1 espresso
8. Portafilter and funnel filler
9. Cup-holder tray
10. Buoy
11. Drip tray
12. Coffee bean tank cover
13. Coffee-bean tank
14. Water tank cover
15. Water tank
16. Steam tube
Control panel
Img. 2
1. On / Off
2. Grind coffee
3. Preparing 1 coffee
4. Preparing 2 coffee
5. Hot water
6. Steam

2. BEFORE USE

Take the product out of the box and remove all packaging materials, stickers, etc.
Make sure all parts and components are included and in good conditions. If any visible signs of
damage are observed, contact the Technical Support Service immediately.
Fill the water tank with water.
Note: It is suggested to use bottled water in order to achieve optimal taste of coffee.
Insert the portafilter into place and turn it anticlockwise to lock it tightly.
Place a container on the cup-holder tray and connect the machine to a power supply. Make
sure the steam dial is in vertical position.
Press the power button, the coffee machine will start pre-heating and then will enter standby
mode.
34 POWER ESPRESSO 20 BARISTA CREAM
Press the hot-water button to dispense hot water. Press again to stop. Then, press the
espresso or double espresso button to clean the inner tubing system.
Use warm water to clean all the coffee machine's parts.
Assemble the funnel by turning it anticlockwise.
Assemble the cup-holder tray, plug the appliance and press the power button. The power
indicator will flash and the device will start pre-heating until the indicator becomes white.
Keep pressed the hot-water button so how water and steam will come out the funnel. After
this ends, empty the cup-holder tray.
The device will make a noise when pumping water for the first time. This is perfectly normal.
During pre-heating, turn the steam dial to standby status.

3. OPERATION

Brewing coffee and hot-water function
Fill the water tank without exceeding the Max mark.
Connect the coffee machine to a power supply and make sure the steam dial is set at the off
position. Then the device will start pre-heating.
The corresponding indicator lights are above the function indicators. There are three indicator
lights around the dial and one operating indicator light on each side.
Coffee, hot water and steam functions cannot operate at the same time.
Pre-heating
Press the on/off button, the coffee machine will start pre-heating while the on/off indicator
light blinks.
Standby
Once it is preheated, the device will enter standby mode and the 4 indicator lights and the
steam indicator will turn steady.
Single espresso
In standby mode, place an espresso filter in the portafilter, pour 13 g of ground coffee into the
filter and tamper. Align the portafilter with the portafilter bracket, insert it into place and turn
it anticlockwise to lock it. Place a cup on the cup-holder tray. From the standby mode, press
the single coffee button, the indicator light will blink and the machine will start brewing coffee.
The function will end automatically. If desired, it can also be stopped manually by pressing the
single espresso button again.
ENGLISH
POWER ESPRESSO 20 BARISTA CREAM 36