Table of Contents
Advertisement
5.5.2 Using the TiWiConnect Web Application
To view the interface for your specific Sterling-LWB:
1.) Enter the Bluetooth address of your Sterling-LWB module with no spaces or semicolons and in
lowercase (e.g. 0025ca076920), then press the SELECT button. If you don't know what the
Bluetooth address is, you can see it displayed in the device list view of the mobile app.
2.) If your Sterling-LWB is online and reporting (you can verify this by watching the serial debug
output to see if there are sensor values being displayed periodically), you should see values
updating in real-time for Heading, Pitch and Roll.
3.) As you slightly rotate and adjust the orientation of your expansion board, you will see the box
on the web application re-orient to reflect the new reported sensor settings. This demonstrates
monitoring sensor data from the web application.
4.) You can control the state of four LEDs on the discovery board (red, orange, blue, green) by
clicking the circles under the heading LEDs on the web application. Allow a few seconds before
clicking again to make sure the command has time to propagate through the cloud to your
Sterling-LWB. The state of the LEDs is reflected on the web app by "dimming" the circle of that
LED's color. This demonstrates remote control of a device via the web application.
The information in this document is subject to change without notice.
330-0234-R1.2
Copyright ©2016-2017 LSR
Sterling-LWB STM Expansion Board
USER GUIDE
Page 21 of 25
Advertisement
Table of Contents
