Downloading An Application To Your Sterling-Lwb Stm Expansion Board; Installing The Wiced Jtag Adapter Driver - Laird LSR STERLING-LWB STM Quick Start Manual

Sterling-LWB STM Expansion Board
USER GUIDE

3.5 Downloading an Application to your Sterling-LWB STM Expansion Board

3.5.1 Installing the WICED JTAG Adapter Driver

In order for your PC to recognize the Sterling-LWB STM Expansion Board as a WICED-compatible JTAG
adapter, you must first install drivers included with the WICED SDK. To install these drivers, go to the
"Device Manager" and locate "Other devices  USB <-> Serial Converter" and right-click it, then click
"Update Driver Software".
Next, click "Browse my computer for driver software"
In the next dialog, click "Let me pick from a list of device drivers on my computer"
Select "Show All Devices", then click "Next". Click the "Have Disk" button and use the "Browse..." button
to navigate to the location where you installed the WICED SDK, then select the "43xxx_Wi-
Fi/tools/drivers/BCM9WCD1EVAL1/BCM9WCD1EVAL1_A.inf" file and click "Open". Click "OK" to select
this as the driver for the USB <-> Serial Converter.
Select "WICED USB JTAG Port" and click "Next"
Finally, click "Close" to finish installing the WICED USB JTAG Port. If the installation succeeded, you
should now see a WICED USB JTAG Port in the device manager.
The information in this document is subject to change without notice.
330-0234-R1.2 Page 14 of 25
Copyright ©2016-2017 LSR