Operation Of Winder 1 - Olympus 1 Instructions Manual

OPERATION OF WINDER 1

Attaching the Winder 1
Remove the motor drive socket cap.
Remove the motor drive socket cap
from the camera base plate by rotat-
ing it counter-clockwise with a coin
until the index dot on the cap is
aligned with the index dot on the
camera.
To replace the cap, align the index
dot on the cap with the index dot on
the camera, and turn the cap clock-
wise with a coin until the index dot
on the camera is aligned with the
groove on the cap.
(The removed motor drive cap can be
stored in the socket cap storage posi-
tioned on the underside of the battery
holder compartment.)
Pull up and rotate the switch dial to
the "OFF" position.
Attach the Winder 1
Remove the M.6V Battery Holder 1
from inside the winder, insert four 1.5
V penlight (AA) size batteries into the
battery holder, and put it back into the
compartment.
Insert the motor drive guide pin into
the guide pin hole on the camera base
plate. To assure proper connection, ad-
just the position of the Winder 1 until
it is flush with the camera. Turn the
clamping screw clockwise until the
Winder 1 is securely attached to the
camera base plate.
The Winder 1, designed primarily for
single-frame shooting, operates on
four self-contained AA batteries and
is extremely compact and light. The
unit advances the film and cocks the
22
Taking the pictures
Pull up and rotate the switch dial
to the "SINGLE" position.
Press the shutter release.
shutter as soon as exposure is made
(wind-on time—0.3 sec.),
the photographer can always be ready
to freeze the subject at the right
moments.
so that