Olympus 1 Instructions Manual page 25

Attaching the M. 15V Ni-Cd Control
Pack 1
Prior to use, the Control Pack should be
checked to insure that it has been ade-
quately charged. If its charge is inade-
quate, use the M. 15V Ni-Cd Charger.
Aligning the red index lines of the Motor
Drive 1 and the Control Pack, engage the
mount catch. Then push the Control
Pack forward and upward until it snaps
on the motor drive, then clamp securely.
Photography with the Motor Drive
Units
Using the M. 18V Control Grip 1
Unlock the shutter release lock lever
on the Control Grip by moving it for-
ward and upward.
* The lever is provided
the shutter release on the Control Grip
for safety sake in general or when a
relay cord is used.
Turn the mode selector on the Con-
trol Grip to either "SINGLE" or "SE-
QUENCE". Set the mode selector to
the "OFF" position when the Motor
Drive 1 is not in use.
* At "SINGLE", exposure is possible
at all shutter speeds from 1 sec. to
1/1000 sec.
At "SEQUENCE", exposure is possible
at all shutter speeds except B. and 1 sec.
24
You may use either the shutter re-
lease on the Control Grip 1 or the shut-
ter release on the Motor Drive 1 to trig-
ger the shutter. It is generally more con-
venient to use the shutter release on the
Control Grip when the camera is held in
to lock
the horizontal position and the shutter
release on the Motor Drive 1 when the
camera is held in the vertical position.