Installation; Installing And Uninstalling The Rs 485 Repeater - Siemens SIMATIC RS 485 Manual

Hide thumbs Also See for SIMATIC RS 485:

Table of Contents

Installation

4.1

Overview

You can install the RS 485 repeater as follows:

● On an S7-300 mounting rail

● On a standard mounting rail (order number 6ES5710-8MA..)

Installation on an S7-300 mounting rail

To install the RS 485 repeater on an S7-300 mounting rail, the catch on the rear of the

RS 485 repeater must first be removed (see the following figure):

1. Insert a screwdriver below the tongue of the catch (1) and

2. Push the screwdriver towards the rear of the module (2). Hold the screwdriver in this

3. Using your free hand lift the catch up as far as it will go and then remove the catch (3).

4. Fit the RS 485 repeater into the S7300 mounting rail (4).

RS 485 Repeater

Manual, 02/2011, A5E03382072-01

position!

Result: The catch of the RS 485 repeater is released.

Result: The catch is removed from the RS 485 repeater.

Table of Contents