Poor Image Quality - Olympus CAMEDIA C-211 Zoom Operating Instructions Manual

Monitor visibility is poor.
Monitor brightness requires adjustment.
Adjust the monitor brightness. (p.169)
The monitor's light-entry lid should be opened or closed.
If surroundings are bright, open the monitor lid. If surroundings are dark, close the
lid. (p.47)
The monitor is broken.
Have the camera serviced by an authorized Olympus service center.
"Image protect," "erase frame," "erase card," and "format card"
functions do not operate.
The card is protected by a write-protect seal.
If you're sure you wish to proceed, remove (and discard) the seal.
Error occurs when transferring data from the camera to a computer.
(An error message appears on the computer screen.)
The cable is not correctly connected.
Fix the connection. (p.185)
The camera is turned off.
Turn the mode dial to
Batteries are dead.
Replace the batteries, or use the optional AC adapter. (pp.28, 31)
The computer's USB port is not set up correctly.
Check the USB setup at your computer. (p.185)

Poor Image Quality

Picture is out of focus.
You may have jerked the camera when full-pressing the shutter release button.
Hold the camera steady and press the button smoothly when shooting. (pp.46, 50)
The point you wanted to focus on was not at the center of the autofocus target mark.
Position the camera so that the point you wish to focus on is at the center of the
monitor. If you wish to focus on a point that is off-center, use the focus-lock feature.
(pp.48–51, 80)
The lens is dirty.
Clean the lens.
196
. (p.187)